Welcome! Register now to see your pricing!
Close
Supertanium® - Solid Carbide Drill Bit Set, 1/8" - 3/8" Diameter (Pack of 1)
SDS
• Modified relief angles on a 135° point penetrate the workpiece easier while maintaining a durable outside cutting edge
• Titanium CarboNitride (TiCN) coating improves heat resistance and reduces wear to the cutting edges; outperforms Titanium Nitride (TiN) coatings
• Three-flute design removes chips effectively
• Three flats are ground on the shanks (size 1/4" and greater) to reduce the chances of slippage and breaking
• No cutting fluids are needed for Cobra™ Drill Bits
• For use on heat-treated, hardened material up to Rc 65
• Recommended for drill press operation only
NOTE: Cobra™ Drill Bits should be run at higher speeds than standard high-speed steel twist drills. It is also recommended that a woodpeckering technique be used to prevent chips from clogging in the flutes.
CAUTION: Any cutting tool may break or shatter under improper use. Government regulations require use of safety glasses and other appropriate safety equipment at all times in the vicinity of use.
| ITEM# | DESCRIPTION | QTY |
| P58026 | Supertanium® Solid Carbide Drill Bit, 1/8" | 1 |
| P58029 | Supertanium® Solid Carbide Drill Bit, 3/16" | 1 |
| P58044 | Supertanium® Solid Carbide Drill Bit, 1/4" | 1 |
| P58047 | Supertanium® Solid Carbide Drill Bit, 5/16" | 1 |
| P58050 | Supertanium® Solid Carbide Drill Bit, 3/8" | 1 |
| A1X67 | Supertanium® Cobra Drill Bit Case, Wood | 1 |
• Modified relief angles on a 135° point penetrate the workpiece easier while maintaining a durable outside cutting edge
• Titanium CarboNitride (TiCN) coating improves heat resistance and reduces wear to the cutting edges; outperforms Titanium Nitride (TiN) coatings
• Three-flute design removes chips effectively
• Three flats are ground on the shanks (size 1/4" and greater) to reduce the chances of slippage and breaking
• No cutting fluids are needed for Cobra™ Drill Bits
• For use on heat-treated, hardened material up to Rc 65
• Recommended for drill press operation only
NOTE: Cobra™ Drill Bits should be run at higher speeds than standard high-speed steel twist drills. It is also recommended that a woodpeckering technique be used to prevent chips from clogging in the flutes.
CAUTION: Any cutting tool may break or shatter under improper use. Government regulations require use of safety glasses and other appropriate safety equipment at all times in the vicinity of use.
This product will be available later
